Change from single PC to Multiuser

[jjobin@hotmail.com]

How do I change from Single PC to Multi-User? I can't find the information in the documentation or forum.

[SYSOPS]

Does this help?

http://www.zfirm.com/Product_Documen...r_ShipRush.htm

SYSOPS

[jjobin@hotmail.com]

Well, not really.
I'm at conflict with "Method 1 (via service - preferred method!)" which i want to use.
But then there is this "Networking a new environment (no ShipRush installed)"
Which is false because I already have SR running on a standalone PC.

[SYSOPS]

Since you have ShipRush installed already, check to see if the service is present. For some carriers, it is installed even for a stand alone installation. If the service isn't there, you can manually add it

http://www.zfirm.com/Product_Documen...sh_Service.htm

Note that a port needs to open if a firewall is present. Now that the service is installed and running, you can install ShipRush on a second machine, and point to this machine as the "server" instance.

HTH,
SYSOPS

[jjobin@hotmail.com]

Success.
While I had access to these same instructions, the terminology does not match that of SR V12 and while I tried several different settings I was not doing something correctly (obviously).
Referencing this document:
http://www.zfirm.com/Product_Documen...h_v12-1_FedEx/

The difference in the section of the DOC vs. SR are here.

DOC: Workstation, 1.After ShipRush is installed, go to the Settings | Shipping Settings | Advanced | Connection Settings and select to connect via PC name. Select the name of the PC the ShipRush service and database is installed on.

SR V12: 1.After ShipRush is installed, go to the Settings | Shipping Settings | Advanced | Connection Settings and select to connect via ShipRush Server At: xxx.xxx.xxx.xxx. Enter the IP address of the of the PC the ShipRush service and database is installed on.

[SYSOPS]

Good to hear and thank you for the follow up.

Normally you can simply use the name of the PC that the service is running on.

SYSOPS